unconfigure inline-power classification

unconfigure inline-power classification ports port_list

Description

This command configures PoE port-level classification power-up mode for Extreme Networks PoE devices that do not support 802.3bt when connecting to switches with 60W/90W PoE ports. ExtremeSwitching platforms support per-port basis configuration.

Syntax Description

classification Classification power-up mode.
ports Specifies the port.
port_list Port list separated by a comma or - .

Default

Depends on the maximum classification level supported by the platform. For example, the 5720 Series has a default classification level of 802.3bt-type4, while 5320 Series has a default classification level of 802.3at.

Usage Guidelines

This command restores port-level classification power-up mode to default based on port type.

Example

# show inline-power configuration ports 20-26
Port   Config    Operator Limit  Priority   Detection                   Classification    Label
20     Enabled   60000 mW        Low        802.3af-only                802.3pre-bt       N                    
21     Enabled   60000 mW        Low        802.3af-only                802.3bt-type3     N                    
22     Enabled   60000 mW        Low        802.3af-only                802.3bt-type3     N                    
23     Enabled   45000 mW        Low        2-point legacy-and-802.3af  802.3bt-type3     N                    
24     Enabled   60000 mW        Low        802.3af-only                802.3at           N      model name-port10   
25     Enabled   90000 mW        Low        4-point legacy-and-802.3af  802.3pre-bt       N                    
26     Enabled   90000 mW        Low        802.3af-only                802.3bt-type3     N     

History

This command was first available in ExtremeXOS 31.3.

Platform Availability

This command is available on:

PoE+

PoE++